Angle grinders are used when grinding steel bars and other products or performing other processing. Let's take a look at correct use of angle grinder and how to install cutting disc of angle grinder before use.
1. How to install cutting disc grinderActually, installation is very simple, first install angle grinder baffle, and then tighten internal fixing nut. Then you can proceed to install cutting disc.
Many acquaintances doubt installation of angle grinder cutting disc. Do I need to install front and back sides separately? Not if front and rear installation will cause a break.
Everyone has searched and you should know that there are different opinions on internet, one says there is a piece of iron to put inside and another one says there is no difference between positive and negative. Actually, safer way is to read manual, installation guide in manual is according to product we purchased. If there is no instruction manual, you can contact customer service or sales staff to understand.
Install cutting blade, tighten nut and install handle.
2. Precautions when using an angle grinder
Before using angle grinder, install guard first. Before installing and starting, hold handle firmly to avoid falling when starting, which may cause injury or damage to machine.
When using, be careful not to stand where angle grinder generates chips, because flying iron chips can easily cause injury. During construction, it is recommended to wear safety goggles to protect your eyes.
After use, be sure to store it properly even if power is turned off, and handle it carefully so as not to damage machine. And do a good job of maintenance to prolong service life of machine.
The above is knowledge of angle grinder in this article, I hope it will be useful to you. I don't know what else you want to know about angle grinder, you can leave a message and tell me~