Beginner in woodworking, hand tools essential for traditional woodworking

Beginner in woodworking, hand tools essential for traditional woodworking

There is no very precise standard for the tools that beginner woodworkers should prepare because woodworking is divided into traditional woodworking, modern woodworking (factory work) and decorative woodworking. Most joiners on the construction site now understand some traditional woodworking techniques and modern woodworking techniques. Let's first introduce the tools that beginner traditional woodworkers need to prepare. Take the simplest table as an example, you need to prepare a sawing table, planer, hand saw, hammer, chisel, tape measure, square ruler, pencil, inkwell, etc. ( In the 1980s, when my father started working as an apprentice, he only had four tools: planer, hammer, saw, and tape measure. to get started.They need a lot of tools when they start learning.Tools are mostly familiar) The following is a brief introduction to the tools that modern start-up woodworking companies need to prepare, using the indoor ceiling as an example, need to prepare: air pump, straight nail gun, steel nail gun, wind mixture, electric hammer, adjustable wrench, table saw, panel saw, tape measure, pencil, woodworking knife, pencil, level, cutting machine, brief introduction process 1 : Drill holes with an electric hammer, then cut out the hanging rods and auxiliary keels on the cutter, and install spacer screws. 2: Install the hanging beams, main keel, auxiliary keel and horizontal wooden fence square, and then level the auxiliary keel with a spirit level. 3: After leveling, proceed with the installation of drywall, screw in the screws with an air portion or an electric drill, and you're done.

Beginners in traditional woodworking need three saws.

Beginner in woodworking, hand tools essential for traditional woodworking

A sieve saw is used to crush and draw materials.

When a cut-off saw is used to cut the material, the middle is large and the two ends are small.

A hand saw is used to saw through spikes and broken ledges.

The selection of material consists in dividing the saw teeth from the left, middle and right. When sawing, the saw is not clamped, and the teeth are cut off with a file so that the saw is sharp and saves strength when sawing wood.

Three planes are needed for beginner carpentry. The large planer is called planer, the middle planer is called Erhutou, and the small planer is called mesh planer.

Beginner in woodworking, hand tools essential for traditional woodworking

The planer is used to align and dock with the board. Also known as planer.

Erhutou is used for wood roughing.

Clean planing is used for final cleaning. It is generally used after woodwork has been completed to keep the wood clean and smooth.

There is also a square ruler to check the verticality of the treated wood and draw a line at a 90 degree angle. An eight-digit ruler is used to draw lines at a 45 degree angle, and a chisel is used to drill holes, material scales, triangular files, oil stones, etc.

Beginner in woodworking, hand tools essential for traditional woodworking

So you can basically work and you need a hand drill. In the process of practice, you need to constantly add tools such as planer, planer, planer, single line planer, etc.

There are many homemade tools that you will slowly learn!