Paint tool
Oil brush
There are many types of oil brushes, and the most commonly used are flat oil brushes made from zhuchun. Specifications: inch, 1 inch, 11/2 inch, 2 inch, 21/2 inch, 3 inch, 4 inch and so on. When using the oil brush, hold it firmly with your hands, the oil brush should not dangle in your hand during operation. When painting doors, windows, walls, metal surfaces, etc., hold the oil brush with your thumb, index, and middle fingers. As you work, use your wrist to turn up and down, and sometimes use your hand and body to interact. After smearing the cane oil with oil, lightly stroke both sides inside the oil barrel, the goal is to stroke the wetted paint on the oil brush head, so that the paint does not hit the ground and other objects.
Oil brush storage:
1. Rinse with kerosene and dry.
2. An oil brush treated with lead oil and mixed paint can be soaked in water for later use. If the storage time is too long, it is better to wash or hang in water so that the bristles do not touch the bottom, otherwise it will be deformed. Oil brushes treated with clear oil should not be soaked; after washing, wrap them in paper for later use. Oil
Blade
A spatula is also known as a spatula. The following specifications are commonly used: 1 1/////////2
inch, 3inch, etc. The spatula is mainly used for dusting and mixing putty. When dusting, sharpen the spade knife and carefully sharpen the two corners. Clean along the grain of the wood so as not to damage the wood; when mixing putty, use a four-finger pen, alternately mixing the front and back sides; when cleaning cement mortar blocks on the wall or hard lumps on the metal surface, hold it firmly Hold the knife handle firmly, press the top of the knife handle firmly with your thumb and scrape vigorously.
Bull horn deformed
Niujiaoqiao is a thin sheet of buffalo horn that is specially used for pouring putty. 1" inlaid wood windows, 11/2" inlaid wood doors, 2" package wood doors and windows, and 3" and larger lots of large areas and floors. Niujiaoqiao itself is elastic, when using it, the head must be thinned and sanded so that the putty can be collected. When putting putty, one end of the horn should be turned at a 20° angle, and the slope should be thinner, and then gradually thickened in the opposite direction, so that the elasticity is good. When inserting the putty, scrape the horn up and then down to fill the holes with putty; when setting the putty, hold the horn with your thumb and the other four fingers. When coordinating wooden doors, windows and furniture, putty can be applied to the entire surface of the object, andthen scrape it off with the horn. Hold the horns with both hands when setting the floor. You can spread the putty on the floor along the grain of the striped wood, and then use the horns to press the putty firmly to repair and scrape off. If the bull horns are deformed after being in them for a long time, they can be soaked in boiling water, taken out and pressed down with a heavy object with a flat bottom surface, the original shape can be restored in a day, and it can be used immediately.
Draw
Pai's pens are made of wool and thin bamboo tubes. 4 tubes and 8 tubes are mainly used for painting chips.
More than 8 tubes are mainly used for wall painting and brushing. When brushing, you need to use your wrist to adapt to up, down, left, and right movements, and you can't use your whole hand to work.
When dipping oil or cane pulp into the bucket, loosen your thumb slightly, shake the pad so that the wool head is down, and tap the side of the bucket with the pad twice after dipping, so that the oil or porridge concentrates on the wool head, and then the brush can be painted as it is. The method of holding the paint sheet is different from the method of applying oil and slurry, and should be held in the middle of the top of the handle.