How to install an angle grinder cutting disc, whether there is a front and rear - a controversial topic. In this article, we will answer it.
There are generally no positives and negatives for cutting discs, but some cutting discs are wrapped with small iron rings in inner hole, single or double bread. If it is one-sided, side with iron sheet is facing inward. If it is two-sided, then there is no difference.
During installation, retailers usually put side with trademark outward, i.e. in direction of people, because in this case the trademark is more visible.
Note difference between a grinding wheel and an angle grinder cut-off wheel. Used for cutting. Among them, grinding disc has a front and back, and iron plate disc has a front. When using grinding disc of an angle grinder, in order to save money and reduce number of grinding disc replacements, it is necessary to properly maintain it.
When cutting with an angle grinder, be careful not to use water during operation, because at present, market is mainly resin cutting discs and diamond cutting discs, and resin cutting discs will be affected by water and moisture, which will affect cutting surface, and also damage cutting surface. Violation of operator's safety.
When installing a new cutting disc, pay attention to two static balances. After static balancing, install grinder and use a diamond pencil to shape cut-off wheel, then remove cut-off wheel and perform static balancing before installation and use.
This time above is contents of an angle grinder cutting disc and I hope to answer your confusion.